University of Twente Student Theses

Essay

Baltima, Anastasia-Anna (2021) Sustainable Energy Planning on the Power System of the Greek Islands based on Green Hydrogen development (Case study: The Island of Crete).

Benet i Bertran, Joan (2019) Computational model of action selection in Parkinson's disease and the effect of deep brain stimulation.

Bergsma, M (2016) Item availability restricted.

Blees, Ricardo (2020) Incineration or pyrolysis for processing un-separated household waste? : An exploration of pyrolysis for non-recyclable but flammable household waste within a case study.

Bloem, J.S. (2023) Hypertrophic cardiomyopathy : the changes in the non sarcomeric cytoskeleton linked to the nucleus.

Blom, M.J.W. (2015) Evaluation of gasification efficiency of glucose and sorbitol under hydrothermal reforming conditions in an autoclave batch reactor.

Boggelen, C. van (2020) Removal of volatile organic compounds and other odourous compounds using ozone generated by UV-C light in aerobic digestion installations.

Bonnema, M.J.S. (2022) Inline Micro-fluidic Relative Permittivity Sensor Based on Silicon Wafer Technology.

Buijs, F.A.H. (2023) The effect of charged single chain polymeric nanoparticles on alpha-synuclein aggregation in SH-SY5Y cells.

Bullee, P.A. (2012) Oleophobic surfaces by PDMS molding : from simple techniques to advanced surfaces.

Chennaveeranahalli, D.R. (2023) Fabrication and analysis of glucose sensor.

Cloet, J.M. de (2017) Extracting the reaction kinetics of the formation of CIGS from in-situ X-ray diffraction measurements.

Dan, C. (2022) Electrospinning and characterization of ZrO2 nanofibers functionalized with palladium sites.

Derckx, E.G.H (2017) The Influences of Hydrogel Geometry on the Desalination of Salt Water.

Dijk, Vic van (2011) The influence of water vapour on the photocatalytic oxidation of cyclohexane in an internally illuminated monolith reactor.

Dijkhuis, D.G. (2017) Mass transfer in titania photocatalytic membrane reactors.

Duursma, I. (2021) A novel strategy for the treatment of osteoarthritis by restoring joint homeostasis using natural antagonists.

Eijsker, J. (2017) Investigation of immiscible liquid-liquid displacement in Slippery Liquid Infused Membranes (SLIM).

Elbert, Thieme (2021) Using FRET probes to determine state of disassembly of cowpea chlorotic mottle virus.

García Martínez, J.B. (2020) Study of water adsorption on an amine adsorbent for Direct Air Capture of CO2.

Geessinck, Jaap and Gerritsen, Maikel (2012) Maximizing the piezoelectric properties of thin film Pb(mg1/3Nb2/3)O3-PbTiO3.

Geraets, E.K.W. (2023) Isolation of HepG2-derived extracellular vesicles in spiked human blood serum using magnetic beads and click chemistry.

Goor, C. van de (2015) Influence of temperature and pH on the hydrogen evolution reaction (HER) on platinum.

Groen, Maarten (2011) Investigation into the transport properties of isolated FePt nanoparticles using STM.

Han, N.I.C.L. (2023) The Effect of α-Synuclein Phosphorylation on the Chaperone Activity of 14-3-3.

Harder, C.M.L. (2016) Practicum ‘Verbrandingswarmte kaarsvet’ in 4 havo : problemen en mogelijke oplossingen.

Hartog, Tessa G. den (2019) A supramolecular hydrogel system for 3D embedded bioprinting.

Haverkate, R. (2018) ATR-IR microreactor with ultra fast integrated microvalves for heterogeneous catalytic analysis in the microsecond domain.

Hendrix, J.M. (2018) Impedimetric analysis of the activity of single fluid cracking catalyst particles.

Hilgerink, T. (2016) On-Chip HPLC analysis of drugs of abuse - Analysis of cocaine, morphine and their metabolites using an on-chip HPLC system.

Hoeven, S. van der (2019) Miniaturization and Characterization of a Ruthenium Oxide Potentiometric pH Sensor for Organs-on-Chip purposes.

Hofsteenge, J.W. (2021) Implementation and Validation of FGM in CFX for the Description of Turbulent Non-Adiabatic Premixed Combustion.

Hogenberk, F. (2020) Moleculaire dynamica simulaties in het voortgezet onderwijs.

Hopman, Niels (2017) De ontwikkeling en het testen van een praktische module scheikunde : de synthese van een biologisch afbreekbaar plastic. poly(ε-caprolacton)(PCL).

Horsman, B.F. (2021) A first principles study on the ferroelectric properties of the phases of hafnia.

Hunt, I.Y.S.E. (2020) Kelvin's thunderstorm.

Iyer, Logonadhan (2022) Low temperature combustion kinetics of high mineral paper sludge char particles.

Jager, K.E. de (2023) Development of a microfluidic device for point-of-care testing of free thiol levels in plasma : A lab-on-a-chip for biomarker detection of oxidative stress in IBD patients.

Jorissen, Koen F.A. (2017) Transport Phenomena in Monolayer Graphene Membranes.

Kambartsumjan, Arthur (2018) Optimizing the process of nitrite measurement.

Kamphuis, E.C. (2017) Desalination on Microscale - The Effect of Salt Concentration on the Desalination Performance of a Microfluidic Device.

Knoef, M.J. (2017) Attending to the knowledge, skills, and attitudes of teachers and students : guidelines for context-based chemistry curricula.

Koolstra, Rense (2015) Photocatalytic watersplitting with WO3 and SrTiO3 : Rh on a chip.

Kroes, Jorrit (2015) Optimization of temperatures in a condensing CO2 to methanol reactor.

Lee, T.K.H. van der (2023) Kinetic modelling of LDPE hydrogenolysis using non-linear regression.

Li, Jing (2017) Patterning porous catalyst using wettability contrast and kinetic study of fructose dehydration.

Marquez Ortiz, Aislinn (2020) Essay #80752

Maryam, Sahlabadi (2023) Balancing Energy Transition Policies & Sulfur Recovery Efficiency in the Netherlands.

Meevis, Y.H.W. (2023) Quantitative spectroscopic photoacoustic imaging using reference fluence method.

Menke, R. (2015) Fabrication of a full-ceramic hydrophobic membrane for water desalination.

Mentink, Sven (2023) Isolation of Hepatocellular carcinoma (HCC) derived extracellular vesicles Using click-chemistry conjugated immunomagnetic beads.

Michorius, M.X.R. (2022) The use of Rayleigh-Raman scattering to investigate milk fat globules.

Mok, S. (2017) Passive removal of electrochemically produced hydrogen gas in a microfluidic device.

Moll, Lüders (2014) Item availability restricted.

Nasseri, Elham (2023) Development of Bio-inspired Hydrogels with Tunable Viscoelastic Properties for 3D Cell Culture.

Nauta, L. (2019) Bioprintability of Dex-TA/HA-TA hydrogels with human iPS cells for cartilage tissue engineering.

Nguyen, Q.H. (2022) Machine learning in the calibration process of discrete particle model.

Nijland, Maarten (2010) Anything you build on a large scale or with intense passion invites chaos.

Pazos Urrea, Monica (2019) Concentration and Esterification of Lactic Acid in Complex Coacervates.

Plugge, M. (2015) Researching the stability of CaO from different precursors under varying absorption times.

Porsul, I.R. (2023) Item availability restricted.

Pouw, Fienie (2022) Oxygen sensing in a 3D cell culture using an oxygen-sensitive dye based on a Ru(II) complex.

Pradhan, S. (2022) Concept design of a novel Ferrofluid based feedback system for a primary system of a versatile endovascular assisting robot.

Rangel, V.R. (2021) 3D Bioprinting in Bioactive Embedding Bath Cartridges for the purpose of Vascularization.

Ridderhof, C.P.J. (2017) Determining design relations for a magneto caloric device with multiple magneto caloric materials using numerical software.

Roghair, I. (2007) Development of an experimental method to investigate the hydrodynamics in a fluidized bed using PIV and DIA.

Rooijen, MSc M.J. van (2014) Characterization of capacitive deionization concentration profiles for small volume sample preparation.

Rops, Joyce (2022) Early Detection of Cervical Cancer via Cas13a Mediated microRNA Detection.

Schellevis, H.M. (2017) The effect of membrane topology features on ion transport phenomena.

Scholten, J.N. (2023) Isolation of fibroblast derived extracellular vesicles using magnetic beads and click chemistry.

Schut, Thomas (2017) Sensing of multiple parameters in a micro-fabricated flow system.

Shea, Gary (2019) Item availability restricted.

Sikkink, M.A. (2015) Experimental investigation of the overlimiting current in a micro-nanochannel system : opportunities and pitfalls.

Slob, J.V.M. (2023) Towards multiplex detection of hypermethylated DNA biomarkers on a droplet digital recombinase polymerase amplification platform.

Song, Chunlin (2005) Influence of water vapor on silica membranes: Effect of sorption and percolation.

Steenbergen, J.J. van (2022) Implementation of proximity ligation assay to quantify low protein concentrations in low volume samples.

Steenge, Céline (2022) Establishing a thermal atomic layer deposition process for AlGaN.

Stronkman, Eva (2022) Item availability restricted.

Szewczyk, J. (2022) Item availability restricted.

Thirukokaranam Chandrasekar, Krishna Kumar (2016) Tracking and Control of Soft, Self-Folding Miniaturized Agent using Ultrasound Images.

Timmerhuis, N. (2015) In-situ characterization of thin layer polysulfone in water-toluene mixtures.

Timmerhuis, N.A.B. (2017) Two (L-L) and three (G-L-L) phase extraction processes in capillaries with heterogeneous surface wettability.

Tjeerdsma, D. (2020) Reaction pathways in the dehydration of propyleneglycol over scandium oxide catalyst.

Toet, M.J. (2023) Development of a Ligament-on-Chip Aligning PDL-hTERT cells on a PDMS membrane.

Vasileios, Papadimitriou (2015) Templated Activated Carbon for Electric Double Layer Capacitors.

Veerbeek, I.H. (2018) Toetsanalyse bij havo 4 in de scheikunde sectie op het Noordik te Almelo.

Veerbeek, Janneke (2012) Electrochemically controlled gradients : towards directed motion of molecules.

Veldscholte, Lars (2017) Birch-type reduction of anthracene by field emission of electrons in microreactors.

Veldscholte, ir. Lars (2020) Coarse-grained Molecular Dynamics Simulations to Study Vapour Solvation in Polymer Brushes: On the border between polymer physics and computational science.

Veltkamp, Henk-Willem (2014) A plug based micro solid phase extraction (uSPE) microfluidic chip for the isolation and purification of DNA.

Verburg, D. (2018) Biodegradable sensor nodes. Zero ecological impact nodes for wireless sensor networks.

Villavicencio Arzola, P.O. (2020) Primary interactions between cellulose and lignin during fast pyrolysis of lignocellulosic biomass.

Vliet, Annemiek van (2023) Combining CRISPR/Cas12a and gold nanoparticles to detect low sample concentrations of nucleic acids.

Vollenbroek, J.C. (2016) Design and characterization of a microreactor for monodisperse catalytic droplet generation at elevated temperatures and/or pressures.

Weening, N.A. (2023) The development of single layer hollow fibers based on PES and PVP K90 for outside-in dialysis.

Wel, T.P. van der (2015) 1D numerical analysis of heat transfer in supercritical water in a heated tube and a single shell and tube heat exchanger.

Wiegerinck, H.T.M (2017) Measurement of the velocity and viscosity of fluids in a micro channel with Optical Coherence Tomography.

Wilbers, Janine (2011) The Flip-chip concept: A new way to electrically characterize molecular monolayers.

Wolf, T. (2016) Design of an Air Factor Sensor based on Light Emission.

Zeilstra, C. (2002) Validation and verification of a discrete particle model in a pseudo 2D (spout-)fluid bed using pressures and digital images.

Zijlstra, B. (2011) Devices for spin injection & detection in graphite.

Zwieten, Ralph van (2015) Debottlenecking bij FrieslandCampina Domo Borculo.

Šćulac, L. (2019) Research into 3D Printed Batteries through Electrodeposition.

Internship Report

Schagen, M.V. van (2011) Item availability restricted.